Applied-motion 3540MO User Manual

User's ManualStep Motor Drivermotors • drives • controlsApplied Motion Products, Inc.404 Westridge Drive • Watsonville, CA 95076Tel (831) 761-655

Connecting Digital Inputs and Limit SwitchesThe 3540 MO contains optical isolation circuitry to prevent the electrical noise inherent in switching amp

-19-AmplifiersInputsRecommendedJoystickSpeed RangesTach OutputPhysicalConnectorsMicrosteppingCE MarkDual, bipolar MOSFET H-bridge, pulse width modulat

-3--18-Choosing a Power SupplyVoltageChopper drives work by switching the voltage to the motor terminals on and off while monitoring current to achiev

The amplifiers in the drive generate heat. Unless you are running at 1 amp or below, you may need a heat sink. To operate the drive continuously at

power connector• DC power supply• motortrim pots• accel/decel rate• low speed• high speedinput connector• run/stop (cw limit)• dir (ccw limit)• high/l

-15--6-0.4AMPS/PHASE0.10.20.40.81.60.5AMPS/PHASE0.10.20.40.81.60.6AMPS/PHASE0.10.20.40.81.60.7AMPS/PHASE0.10.20.40.81.60.8AMPS/PHASE0.10.20.40.81.60.9

-7--14-MicrosteppingMost step motor drives offer a choice between full step and half step resolutions. In most full step drives, both motor phases ar

-8- -13-Oscillator mode is selected by moving switch #1 away from the word Joystick. There are two speed ranges in oscillator mode. One is the low s

-9--12-In both operating modes, the accel/decel rate is set by the ACCEL pot. The range is 1 to 250 rev/sec/sec. Turning the pot clockwise makes the